|
Dental Air Compressor With Minimum 40 Liter Reservoir, With Internal Painting Of The Antioxidant Reservoir, Thermal Protector, Protection For The Electric Motor And Filters At The Air Inlet And Outlet. Serves 1 Or More Dental Offices. Technical Information: Voltage: 110V Or 220V Power: Minimum 1,700W (2.28 Hp), Approximate Theoretical Displacement 424 L/Min, Maximum Pressure: 8 Bar, Low Noise, Warranty: 1 Year And Technical Assistance., Horizontal Tabletop Autoclave Minimum Capacity Of 42 Liters. Fully Automatic Control, Which Must Be Performed Through Microcontroller Temperature Selection: 120 To 134°C Cycle: Up To 60 Minutes. Drying Time: Up To 45 Minutes. Precision And Resistance Time: Type Pt 100. Hydraulic System And Vacuum Pump: With Bronze Filter, Stainless Steel Filter Elements. Solenoid Valve: Diaphragm Type Forged Brass. Safety Valve: Built In Brass. Chamber: It Must Be Made Of Stainless Steel, With A 3-Year Warranty And Externally Coated With Heat-Insulating Material Which, In Addition To Optimizing Its Energy Consumption, Must Maintain The Ambient Temperature. The Addition Of Water To The Internal Chamber Of The Autoclave Must Be Automatic, As Well As The Cycle Must Be Automatic. Tray: Made Of Stainless Steel, Fully Perforated, To Allow Good Steam Circulation. Lid/Door: In Stainless Steel, Laminated, With A 3-Year Warranty, With A Silicone Rubber Sealing Ring Resistant To High Temperatures. Door Closing System Device That Prevents The Equipment From Operating With The Door Open. It Must Be Constructed Robustly And Internally Equipped With A Thrust Bearing That Provides Greater Safety And Smooth Handling. Cables: Must Be Bakelite (Heat Insulated). Resistance: Must Be Nickel Chrome, Armored In Stainless Steel Cable Cabinet: Must Be In Reinforced Stainless Steel Sheet, With Anticorrosive Treatment And Electrostatic Painting, External And Internal. It Must Have An Opening For Venetian Ventilation. It Must Have An On/Off Switch, Display Pressure Gauge And Control Keys. Electronic Safety System: It Must Automatically Turn Off If The Temperature Exceeds The Programmed Temperature By 3°C. Mechanical And Electrical Safety System: It Must Have A Relief Valve, Protection Fuse, Safety Thermostat To Prevent The Resistances And Materials From Burning In The Event Of A Lack Of Water. Built Based On..., High Rotation Pen With Inverted Handle In The Same Direction As The Head, Increasing The Operators Visibility During The Surgical Procedure. Median Head, And Triple Spray For Cooling. High Torque Made From Anodized Aluminum, Which Enables Lightness And Excellent Surface Finish, Facilitating Disinfection; Head With Rounded Lines; Low Noise Level; Supported Bearing System. Weight G 38 To 44. Rotation (Rpm) 0 To 420,000. Attaching The Drill Bit (Drill Driver). Pressure (Psi) 30 To 40. Air Consumption (L/Min) 42. Water Consumption (Ml/Min) 42. Sound Level (Db)69 - Anvisa Registration And Technical Assistance Throughout The State Of Paraná, Intra Mx Contra-Angle With External Cooling To The Body, Attachable To The Micromotor With Intra System Where Torque And Rotation Are Transmitted To The Drill Through A Shaft And Gear Set With 1:1 Transmission Rotation. Anodized Aluminum Body, 360° Free Rotation On The Micro Motor, 20° Degree Angle Between The Long Shaft And The Head Neck
|
