|
Tender For Development Of Irrigation System, Water Facilities And Plantation Area At Ratnagiri Hill, Bhuwana (Phase-Ii) 7701 - 1 Item Code [2022 4.1]:Item Type [building] :: Digging of pits size 60x60x60 cms. Including removal of stones Manuring applicable of insecticides & watering atleast 15 litre per plant after plan ting 2 Item Code [2022 H- 1.3.1]:Item Type [building] :: Supply & Stacking good soil of earth at site completeincluding loading unloading & Transportation etc.Good soil of earth 3 Item Code [2022 S 4.2.3]:Item Type [building] ::Construction of Tube-well upto 100 Meter depth and above in all type of rocks by DTH system and over burden, to accommodate casing pipe of following sizes in all types of soils and over burden including lowering of casing pipes, but excluding cost of casing pipes as per IS : 2800 (Part I & II) 1979 specifications. The work would be completed after obtaining sand free water. The tube well should have a throughout bore as per nominal dia of casing pipe : 150 mm dia Nominal bore 4 Item Code [2022 S 4.5.3]:Item Type [building] :: Supply of ERW M.S. black casing pipe ISI marked (IS:4270/1992) of grade Fe410 of following sizes at site of work.150 mm Nominal bore of pipe 5 Item Code [21.1-2022]:Item Type [Electrical] ::Sub Item Code [21.1-2022 + 21.1.1]: Labour charges for installation of submersible motor pump set including lowering/ delowering of pipes, cables, accessories etc. in tube-well/ open well complete including T&P, transportation of tripod, chain pulley block & any other material required for this purpose complete in all respect.Lowering only 6 Item Code [21.13-2022]:Item Type [Electrical] ::Sub Item Code [21.13-2022 + 21.13.2.2]: SITC of ContactorOEM Fabricated DOL/Star-Delta Starter panel with switchgear selection as per Type-2 Cordinatiom Chart andmade out from 1.6 mm thick powder coated CRCA sheet, enclosure comprising of over load protection relay, short circuit & single phasing protection, Illuminated ON / OFFpush buttons,ammeter, voltmeter, indicating lamps etc.suitable for following rating motors complete in all respect. All as per pre approved by Engineer in charge.For additional technical parameters of products/ work, refer Annexure A attached with this BSR . For Three phase Submersible / Mono block pump3.0 HP to 5.0 HP ( DOL starter ) 7 Item Code [21.3-2022A]:Item Type [Electrical] :: Sub Item Code [21.3-2022A + 21.3.2]: Providing & Laying of Polypropylene rope Confirming to IS:5175 for submersible pump of following sizes. complete in all respect. All as per pre approved by Engineer in charge.For additional technical parameters of products/ work, refer Annexure A attached with this BSR .16mm (suitable above 50mm & up to 75mm OD pipe) 8 Item Code [21.4-2022]:Item Type [Electrical] :: Sub Item Code [21.4-2022 + 21.4.1.2]: Providing & Fixing of HDPE pipe Confirming to IS:4984:2021for water supply suitable for submersible & jet pump with required fittings ie socket, elbows, tee etc. complete in all respect. All as per pre approved by Engineer in charge.For additional technical parameters of products/ work, refer Annexure A attached with this BSR.for vertical installation 50 mm OD6 kg / cm2 9 Item Code [21.4-2022]:Item Type [Electrical] :: Sub Item Code [21.4-2022 + 21.4.1.3]: Providing & Fixing of HDPE pipe Confirming to IS:4984:2021for water supply suitable for submersible & jet pump with required fittings ie socket, elbows, tee etc. complete in all respect. All as per pre approved by Engineer in charge.For additional technical parameters of products/ work, refer Annexure A attached with this BSR.for vertical installation 63 mm OD6 kg / cm2 10 Item Code [21.4-2022]:Item Type [Electrical] :: Sub Item Code [21.4-2022 + 21.4.1.4]: Providing & Fixing of HDPE pipe Confirming to IS:4984:2021for water supply suitable for submersible & jet pump with required fittings ie socket, elbows, tee etc. complete in all respect. All as per pre approved by Engineer in charge.For additional technical parameters of products/ work, refer Annexure A attached with this BSR.for vertical installation 75 mm OD6 kg / cm2 11 Item Code [21.6-2022]:Item Type [Electrical] :: Sub Item Code [21.6-2022 + 26.1.2.2]: SITC of Radial / mixed flow ISI marked water and anti-corrosive liquid filled submersible motor pump setssuitable for 100/150mm dia borewell.The size of adopter fixed on top of the motor should exceed the top of coupler , for safegaurd the coupler. The construction material of motor and pump should match IS: 8034 : 2018 and IS: 9283 guideline. The radial flow pumpset should operate at 5 star energy efficiency level of BEE and mixed flow pump set should operate at 3 star energy level of BEE, accompained by valid BEE certificate. Motor should be IE2 class as per IEC 60034-2-1: 2007, IEC 60034-30: 2008,& IS12615:2011with required accessories including making connection suitable for Bore well. The job includes labour part of lowering ofriser pipe G.I./H.D.P.E. with rope, cables & pump, installation of complete fitting and accessories, jointing of electrical cables up to Starter. All labour for testing of submersible pumps set and supply of water to water mains, complete in all respect. OEM shall have submitNABL / CPRI / ERDA accrediatedlab type test certificate before execution. All as per pre approved by Engineer in charge.For additional technical parameters of products/ work, refer Annexure A attached with this BSR .150 mm diameter Submersible pump shall havefollowing HP Rating, phase, Head range, Discharge range respectively 5.0 HP, 3-Ø, (68 - 102)Mtr, (225-85) LPM 12 Item Code [4.7-2022]:Item Type [Electrical] ::Sub Item Code [4.7-2022 + 4.7.4]: P/Laying ISI marked P.V.C. insulated submersible cable confirming to(IS:694) and as per IS 8130 : 2013 of 1.1 kV grade . Wire should be made from99.90 % purity copper, stranding in acc. to IS:8130/IEC 60228 forlower watt loss , oxygen freefor less chances of oxidization, insulation PVC type A/C/D , flame retardant as per IS 10810-53, better amperage rating as per IS:3961 part 5,existing pipe / open trench / Cable tray / on surface including making connection etc. as required. For additional technical parameters of product / work refer Annexure A attached with this BSR 6.0 Sq.mm 3 core flat / Round 13 Item Code [9.8 2022]:Item Type [building] :: Providing and fixing steel gate grating and grills made of angles, tees, square bars or flats black pipe with holdfast and fittings complete as per deign and drawing including cutting welding and fabrication with priming coat of red oxide. 14 Item Code [BSR 2022 2.2.3]:Item Type [building] :: 2.2 P & F G.I. Pipes (External Work) with G.I. fittings excluding union (IS : 1239 Mark) including trenching & refilling earth etc.2.2.3 25mm dia nominal bore.B class 15 Item Code [BSR2022 1.1]:Item Type [building] ::Supply of dry manure including loadingunloading,transportation & stacking at site.Sub Item Code [BSR2022 1.1 + 1.1.1]: Supply of dry manure including loading unloading,transportation & stacking at site.Farm yard manure(organic) 16 Item Code [BSR2022 1.11]:Item Type [building] ::Supply of different varities of tree/shrubs/climbers according to height and age of the plant at side including loading/unloading & transportation etc.complete. Sub Item Code [BSR2022 1.11 + 1.11.1]: Supply of different varities of tree/shrubs/climbers according to height and age of the plant at side including loading/unloading & transportation etc.complete. Different flowering plants 900mm to1500mm 17 Item Code [BSR2022 1.11]:Item Type [building] ::Supply of different varities of tree/shrubs/climbers according to height and age of the plant at side including loading/unloading & transportation etc.complete. Sub Item Code [BSR2022 1.11 + 1.11.2]: Supply of different varities of tree/shrubs/climbers according to height and age of the plant at side including loading/unloading & transportation etc.complete. Different varieties of shrubs 600mm to 900 mm 18 Item Code [BSR2022 1.11]:Item Type [building] ::Supply of different varities of tree/shrubs/climbers according to height and age of the plant at side including loading/unloading & transportation etc.complete. Sub Item Code [BSR2022 1.11 + 1.11.3]: Supply of different varities of tree/shrubs/climbers according to height and age of the plant at side including loading/unloading & transportation etc.complete. Different varieties of climbers 900mm to 1500 mm 19 Item Code [BSR2022 1.12]:Item Type [building] ::Supply of different varieties of bougainvillea in plybags/earthen pot according to height growth and age of plant at site including loading unloading and transportation etc. complete. Sub Item Code [BSR2022 1.12 + 1.12.2]: Supply of different varieties of bougainvillea in ply bags/earthen pot according to height growth and age of plant at site including loading unloading and transportation etc.complete. Different varieties of bougainvillea 600mm 20 Item Code [BSR2022 2.15]:Item Type [building] ::P & F Full-way Valve (IS:778 Mark) or wheel valve ofapproved make : Sub Item Code [BSR2022 2.15 + 2.15.1]: P & F Full-way Valve (IS:778 Mark) or wheel valve of approved make : Gun-metal 15mm nominal bore. 21 Item Code [BSR2022 2.16.6]:Item Type [building] :: P & F Gun-metal Non-return Valve or Check Valve (IS : 778 Make) of approved make, superior quality:50mm nominal bore. (a) Horizontal 22 Item Code [building 2022 6.1.2]:Item Type [building] :: Random rubble stone masonry for foundation and plinth in cement sand mortar above 30 cm thick wall in 23 Item Code [S 2022 2.26]:Item Type [building] ::Sub Item Code [S 2022 2.26 + 2.26.6]: P & F PVC Storage Tank ISI Marked (IS : 12701) indicating the BIS license No), of approved make with cover, 25mm dia 1M long G.I. over-flow pipe & 25 Cm. long wash out pipe with plug & socket, including making connection etc., complete of approved design:2000 litres capacity 24 Item Code [S-2.29]:Item Type [building] :: Sub Item Code [S-2.29 + S-2.29.1.1]: PE-AL-PE Composite Pressure Pipes and Fittings Providing and fixing Polyethylene - Aluminium - Polyethylene (PE-AL-PE) Composite Pressure Pipes as per 15450-2004 U V stablised with carbon black having thermal stabillity for hot and cold water supply with all compression type composite internal seal fittings (e.g. elbows, tees, reducers, couplers connectors etc) with clamps at 1.00 mtr spacing cutting through walls & making good the same etc (Internal work) Exposed on Wall1216 (16mm OD) pipe
|
