|
Flammable Electrician Uniform Pants; Specification: Flammable Electrician Pants: Aptv: 16, 0 Cal/Cm- Haf: 82, 4%- Risk 2- With Reflective Lanes The Flame. Made Of 100% Cotton Fabric, 3 X 1 Twill, 271 G/M2 Weight In Royal Blue, With Retardant Treatment The Flame And Resistant Electric Arc The Waist Should Have A Waistband On The Same Body Of The Body, But Orange, With Elastic Embedded With 4Cm Width And Folded Into Four -Point Elastique Machine; With Application Of Four Passersby, In Orange, Being: 2 Front And 2 Rear, These Reinforced With Crossings. In The Front Should Be Sewn Two Built -In Pockets, Type Knife With Rounded Edges And At The Edges Of Them, Should Have A Finish, In The Same Fabric Of The Body, With 1Cm Wide. The Piece Will Have Rear Cut, From This Will Come Out Two Embedded Pockets, With Rounded Edges, And At The Edges, 1Cm Wide, Stitched With A Straight Machine Of A Needle. In Front Of The Pants Should Have A Fake View (No Zipper Or Button), This View Should Be In The Same Body Fabric, But In Orange. At Knee Height, A Reflective Track Should Be Sewn To Flames, 5 Cm Wide, Silver And Yellow. In The Leg Bars A Bias Of 1, 5 Cm, But In Orange. The Tolerance Of Tissue Variation Is 5% And The Measurements Is 1Cm. All Pieces Should Be Packed Separately In Transparent Plastic Bags. The Piece Must Be Exempt From Any Defect That Compromises Its Presentation. Seams: - The Pants Should Be All Sewn Internally With An Interlocle Machine; - The Seams Should Be Made With The Precautions Needed To Avoid The Firing Of The Fabric And The Staggering Of The Internal Seams, And All The Edges Of The Fabric Should Be Overlock To Obtain A Superior Quality, Fine Finish And Great, Uniform Flammable Electricist Shirt:. Specification: Flammable Electrician Uniform Shirt: Aptv: 16, 4%- Risk 2- With Reflective Lanes The Flame. Made Of 100% Cotton Fabric, 2X1 Twill, With 192 G/M2 Weight, With Retardant Treatment And Electric Arc Resistant Treatment. The Collar Should Be Sports, Entertained, But In Orange And Fixed In The Piece; With External Finish Through A Straight Machine Of A Needle, Throughout The Collar. Front Opening With Pale, Made In The Same Fabric Of The Body, With 6 Or 7 Buttons Of Pressure, In Plastic Material, White. Long Sleeves And American Fists, Closed By Pressure Button, Plastic, In The Color Of The Uniform. With Reflective Ribbons At The Height Of The Trunk And Elbows, With A Width Of 5 Cm, In Silver And Yellow. On The Front, On The Left Side Of Those Who Wear The Piece, The Coat Of Arms Of This City Hall Should Be Applied And Just Below The Toritama City Hall, In White, In The Process Of Silkscreen, As Image In Appendix Iii - Models. In The Center Of The Back, In Larger Size, The White Writing Should Be Applied, With The Coat Of Arms Of This City Hall In The Center And Just Above It, The Toritama City Hall, As Image In Appendix Iii - Models. The Tolerance Of Tissue Variation Is 5% And The Measurements Is 1Cm. All Pieces Should Be Packed Separately In Transparent Plastic Bags. The Piece Must Be Exempt From Any Defect That Compromises Its Presentation. Seams: - Inside, In The Junction Of The Body With The Sleeves Should Be The
|
