|
Horizontal Tabletop Autoclave Minimum Capacity Of 42 Liters. Fully Automatic Control Which Must Be Performed Through Microcontroller Temperature Selection: 120 To 134°C Cycle: Up To 60 Minutes. Drying Time: Up To 45 Minutes. Precision And Resistance Time: Type Pt 100. Hydraulic System And Vacuum Pump: With Bronze Filter, Stainless Steel Filter Elements. Solenoid Valve: Diaphragm Type Forged Brass. Safety Valve: Built In Brass. Chamber: It Must Be Made Of Stainless Steel, With A 3-Year Warranty And Externally Coated With Heat-Insulating Material Which, In Addition To Optimizing Its Energy Consumption, Must Maintain The Ambient Temperature. The Addition Of Water To The Internal Chamber Of The Autoclave Must Be Automatic, As Well As The Cycle Must Be Automatic. Tray: Made Of Stainless Steel, Fully Perforated, To Allow Good Steam Circulation. Lid/Door: In Stainless Steel, Laminated, With 03 (Three Years) Warranty, With Silicone Rubber Sealing Ring Resistant To High Temperatures. Door Closing System Device That Prevents The Equipment From Operating With The Door Open. It Must Be Constructed Robustly And Internally Equipped With A Thrust Bearing That Provides Greater Safety And Smooth Handling. Cables: Must Be Bakelite (Heat Insulated). Resistance: Must Be Nickel Chrome, Armored In Stainless Steel Cable Cabinet: Must Be Made Of Reinforced Stainless Steel Sheet, With Anti-Corrosion Treatment And Electrostatic Painting, External And Internal. It Must Have An Opening For Venetian Ventilation. It Must Have An On/Off Switch, Display Pressure Gauge And Control Keys. Electronic Safety System: It Must Automatically Turn Off If The Temperature Exceeds The Programmed Temperature By 3°C. Mechanical And Electrical Safety System: It Must Have A Relief Valve, Protection Fuse, Safety Thermostat To Prevent The Resistances And Materials From Burning In The Event Of A Lack Of Water. Built With Base, High Rotation Pen With Inverted Handle In The Same Direction As The Head, Increasing The Operators Visibility During The Surgical Procedure. Median Head, 45º Angulation. High Torque, Made From Anodized Aluminum, Which Enables Lightness And Excellent Surface Finish, Facilitating Disinfection; Head With Rounded Lines; Low Noise Level; Supported Bearing System. Weight G 38 To 44. Rotation (Rpm) 0 To 420,000. Fixing The Drill (Drill Driver). Pressure (Psi) 30 To 40. Air Consumption (L/Min) 42. Water Consumption (Ml/Min) 42. Sound Level (Db)69 - Anvisa Registration And Technical Assistance Throughout The State Of Paraná., Contra Angle Intra Mx With External Cooling To The Body, Attachable To The Micromotor With Intra System Where Torque And Rotation Are Transmitted To The Drill Through A Set Of Shafts And Gears With 1:1 Transmission Rotation. Anodized Aluminum Body, 360° Free Rotation On The Micro Motor, 20° Degree Angle Between The Long Shaft And The Head Neck, Drill Lock By Steel Blade Laterally Moveable At An Angle With Fitting To Adapt To The Channel Drill, Size With Specifications: Spray: With External Spray To The Body, Connection: Intra, Speed: 3,000 To 20,000 Rpm With Reversal, Air Pressure: 60 To 80 (Psi), Air Consumption: 65 (L/Min), Speed Transmission Ratio: 1:1, Autoclavable: 135°C, Weight: 90 G, Noise : 70 Dbs. Anvisa Registration And Technical Assistance Throughout The State Of Paraná., Micromotor Intra Co
|
