|
Construction work of installation of barbed wire dustbin bench and boundary wall in Anubhuti Apartment Sector-S/S Aliganj - Earth work in surface excavation not exceeding 30 cm in depth butexceeding 1.5 m in width as well as 10 sqm on plan including getting outand disposal of excavated earth upto 50 m and lift upto 1.5 m, as directedby Engineer-in- Charge: All kinds of soil. (DSR 2023/2.1.1) 2 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering-All work up to plinth level: 1:4:8 (1 Cement: 4 coarse sand (zone-III) derived fromnatural sources: 8 graded stone adgregate 40 mm nominalsize derived from natural sources). (DSR 2023/4.1.8) 3 Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:4 (1 cement: 4 coarse sand). (DSR 2023/6.1.1) 4 Providing and laying damp-proof course 40 mm thick with cement concrete 1:2:4 (1 Cement: 2 coarse sand (zone-III) derived from natural sources: 4 graded stone aggregate 12.5 mm nominal size derived from natural sources). (DSR 2023/4.10) 5 Brick work with clay flyash F.P.S. (non modular) brick of class designation 7.5 in superstructure above plinth level up to floor five level in : Cement mortar 1:4 (1 cement : 4 coarse sand)(DSR 2023/6.32.1) 6 12 mm cement plaster of mix: 1:4 (1 cement: 4 Coarse sand). (DSR 2023/13.4.1) 7 Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.(DSR 2023/13.80) 8 Finishing walls with Premium acrylic Smooth exteriorpaint with Silicone additives of required shade: New work (Two or more coats applied @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 sqm. (DSR 2023/13.47.1) 9 Steel work welded in built up sections/ framed work, including cutting. hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc, as required : In gratings, frames, guard bar, ladder, railings, brackets, gatesd similar works. DSR 2023/10.25.2 10 Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade: Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture. (DSR 2023/13.62.1) 11 Providing and fxing of 1.50ft diameter Razor cut wire on Y shape MS 40 mm x 5mm angle bracket with 3 straight line GI Barbed wire as direction of Engineering in charge including all material T&P required for proper completion of work. Saction Rate 12 Providing and fixing of Penguin type big size designer dustbin of appoved quality approved by E/I etc made of plycarbonate of equivalent material with mixing different colorfull colours of 3-0"x1/2"0. to 2-0" dia size etc including cartage of dustbin by the contractor their won sources etc including supply of all material T&sP complete work. Sanctioned Rate. 13 Supply & fixing of MS benches including cost of benches (shape & size attached with estime) fixing the wave slide including excavation PCC 1:4:8 cement coarse sand & 40 mm nominal grit with CC 1:2:4 cement coarse sand & 20 mm gauge stone grit including all. material 8& labour required fixing and orienting etc all complete under the direction of the E/I. Sanction Rate. 14 Cleaning of terrace/loft water storage tank (inside surface area) upto 2000 litre capacity atall heights with coconut brushes, duster etc., removal of silt, rubbish from the tank andcleaning the tank with fresh water disinfecting with bleaching powder @ 0.5gm per litrecapacity of tank including marking the date of cleaning on the side of tank body with thehelp of stencil and paint and disposing of malba all complete as per direction of Engineerin-Charge. (The old date already written on tank should be removed with paint remover orblack paint and if date is not written with the stencil or old date is not removed deductionwill be made @ Rs. 0.10 per litre) (if during cleaning any Gl fittings or ball cock isdamaged that is to be repaired by contractor at his own cost and nothing extra wil be paidon this account) (DSR No. 14.75 A by Analysis). Sanction Rate. 15 Digging holes in ordinary soil and refilling the same with the excavated earth mixed with manure or sludge in the ratio of 2:1 by volume (2 parts of stacked volume of earth after reduction by 20% : 1 part of stacked volume of manure after reduction by 8%) flooding with water, dressing including removal of rubbish and surplus earth, if any, with all leads and lifts (cost of manure, sludge or extra good earth if needed to be paid for separately) Holes 90 cm dia, and 90 cm deep. 16 Supplying and stacking of well decayed cattle manure at site including royalty and carriage upto 5 k.m.lead complete (Cattle manure measured in stacks will reduced by 8% for Payment). 17 Supplying and stacking of good earth at site including royalty and carriage upto 20 km lead complete (earth measured in stacks will be reduced by 20% for payment). 18 Providing and stacking of Mimusops elengi (Maulsri) healthy and multi branches of height 10-12 feetin big poly bags of size 18" as per direction of the officer-in-charge. 19 Providing and stacking of Delonix regia (Gulmohar) healthy and multi branches of height 12-14 feet in big poly bags of size 18" as per direction of the officer-in-charge. 20 Providing and stacking of Ficus bengalensis (Bargad) healthy and multi branches of height 10-12 feet in big poly bags of size 18" as per direction of the officer-in-charge. 21 Supply and Fixing of See-saw 2 seater SS-01 22 Supply & fxing of wave slide (m) . SD- 05B (height6") indluding cost of wave slide (shape & size attached with estime) fxinf the wave slide including excavation PCC 1:4:8 Nos cement coarse sand & 40 mm nominal grit with CC 1:2:4 cement coarse sand. & 20 mm gauge stone grit inchuding allj material & labour required, fxing and orienting etc all Complete under the direction of the E/I. Sanction Rate. 23 Construction of granular sub baseby providing close graded material, spreading in uniform layer with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC and compacting with vibratory roller to achieve the desired density as perMORTH 401. 24 Providing and laying factory made chamfered edge Cement Concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over 50 mm a thick compacted bed of sand, compacting and proper embedding/ layingof inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattem, finishing and sweeping extra sand. complete all as per direction of Engineer-in-Charge. 80 mm thick C.C. paver block of M-35 grade with approved colour design and pattern. (DSR 2023/16.91.2) 25 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level: 1:2:4 (1 cement: 2 coarse sand (zone-III) derived from natural sources: 4 graded stone aggregate 20 mm nominal size derived from natural sources) (DSR 2023/4.1.3) 26 Excavating, supplying, stacking and filling of local earth (including royalty) by mechanical transport upto a lead of 5km also including ramming and watering of the earth in layers not exceeding 20 cm in foundation trenches, plinth, sides of foundation etc. complete for all lift. DSR 2023/2.25(a) 27 Supply & Fixing of Swing 4 seater SW-2 including cost of swing seater (shape & size attached with estime) fixing the swing seater including excavation PCC 1:4:8 cement coarse sand & 40 mma nominal grit with CC 1:2:4 cement coarse sand & 20 mm gauge stone grit including all material & labour required fixing and orienting etc all complete under the direction of the E"/I. Sanction 28 Sinageg Board painting and writing (Board size 0.90 x 1.20 mtr) 29 Providing & Fixing 6mm thick Polycorbonate sheet with 35x35 mm (heavy 12kg per lenth) M.S Square hallow pipe with addition aluminium glazing plate on outer face including fastener or hooks, bolts, nuts and wastage etc. required for proper completion of work as per design by engg.in-Charge. Sanctioned Rate.
|
