Tender For Competitive E-Bidding For Supply Of Fabrication And Erection Work Services For E.T.P For Season 2 ... in India

Work Detail

Tender For Competitive E-Bidding For Supply Of Fabrication And Erection Work Services For E.T.P For Season 2024-25, 1 Stiffening of beam of structure made for vapour cell semicancer quad body and pano 2 Modifying and tiling the sulphur burner of old design as per instructions 3 Installing clear juice filtration system between both the clarifiers and tiling it after making necessary connections etc. 4 Making new bucket sample/as per instructions for dry seed elevator and sugar elevator chain 5 Replacing the lane plate of the bottom sensor of pano and welding it with the given special electrode and giving leak proof tile 6 Cutting out the old design bridge drive assembly of cane unloader no. 2 and making and installing the new modified design bridge drive assembly as per instructions and fitting wheel with pinion and gear, aligning the bridge shaft with the modified design assembly of wheels so that the wheel does not rub on the square, replacing the plate above the wheel bearing and giving satisfactory trial after alignment 7 Taking out both the rotary feeders of boiler no. 2 and removing the channel and beam below it and installing another new beam/channel and fitting the rotary feeders and tiling them. 8 Taking out the MS channel and plate behind the steam drum of boiler no. 1 and installing another new one and fitting them. 9 Cutting out the neck top and bottom header of juice heater and fabricating them as per the instructions/sample and erecting them at the designated place and giving a successful trial. The upper end of the partition plate should be machined so that the rubber can fit properly in the groove and be leak proof. 10 Cutting out the cell and cooling jacket of the neck Sativk make sulphur furnace and fabricating a new cell with a 16/20 mm plate as per dyeing/instructions and erecting them at the designated place and tiling them successfully. 11 Take down the Bangasilo cyclone over the vacuum filter and modify it as per instructions and thereafter pre-erect it at the designated place and tile it successfully. 12 Cut and remove the steam coil of the melted sulphur melter and make a new pipe steam coil and erect it in the melter and tile it after hydraulic testing. 13 Cut and remove the Bangasilo mud mixer in which the stator is fitted, make it scarle type and install it at the designated place and deliver it successfully.

Contact Information

Other Detail