|
- Table With Mdf Top And Polypropylene Book Holder, Mounted On A Tubular Steel Structure With Crystal Gray Epoxy Painting And Polypropylene Shoes Minimum Height Measurements 594 Mm X Width 600Mm X Depth 450 Mm. - Paddleable Chair With Seat And Back In Injected Polypropylene Mounted On A Tubular Steel Structure With Epoxy Painting And Polypropylene Tip. Minimum Measurements Height 625 Mm X Width 396 Mm X Depth 310 Mm; Height Up To 350 Mm., Mounted On A Tubular Steel Structure With Crystal Gray Epoxy Paint And Polypropylene Shoes. Minimum Height Measurements 760 Mm X Width 600 Mm X Depth 450 Mm. Steel Tubular Tube With Epoxy Painting And Polypropylene Tip. Minimum Measurements Height 720 Mm X Width 400 Mm X Depth 430 Mm; Height Up To 460Mm., Body Composed Of: Side Pieces, Bottom, Shelf And Partitions In Mdp, Thickness Of 18Mm, Covered On Both Sides With Low Pressure Melamine Laminate - Bp, Textured Finish, In Gray Color (See References) . Finished Dimensions According To Project; Rear Piece In Mdp, 15Mm Thick, Covered On Both Sides With Low Pressure Melamine Laminate - Bp, Textured Finish. Finished Dimensions According To Project; Mdp Top, 18Mm Thick. Upper Face Coated In Post-Formable High-Pressure Melamine Laminate 0.6Mm Thick, With A Radius Of Curvature Of 10Mm, Textured Finish. Lower Face Coated With Low Pressure Melamine Laminate - Bp, Textured Finish. Edges Topped With Pvc Edge Tape (Polyvinyl Chloride) With Primer, Glued With Hot Melting Adhesive. Nominal Dimensions Of 22Mm (Width) X 3Mm (Thickness), For Parts Exposed To Contact With The User. Nominal Dimensions Of 22Mm (Width) X 0.45Mm (Thickness), For Parts Where There Will Be No Contact With The User. Base In Carbon Steel Tube, Cold Rolled, With Seam, Rectangular Section Of 20Mm X 40Mm, In Sheet 16 (1.52Mm), Welded And Perforated. The Pipe Abutments Must Be Welded Around The Entire Perimeter Of The Joint. The Surface Of The Base That Will Be In Contact With The Furniture Must Be Flattened After Applying The Solder. Painting Finish In Epoxy/Polyester Hybrid Powder Paint, Electrostatic, Glossy, Oven Polymerized, Minimum Thickness Of 40 Micrometers. Metal Leveling Shoes, With Injected Polypropylene Base, 3/8 Thread. Fastening By Steel Sheet (Thickness 1.5Mm) With Aluminum Rivet. Fixings: Fixing The Parts That Make Up The Cabinet Body With Devices For Permanent Connection, Consisting Of A Bushing With A Locking System And A Screw With A Wood Thread. Shelf Fixing With Zamac Shelf Support. Fixing The Metal Base To The Cabinet Body Using Metric Machine Thread Screws M6 Table With Particleboard Wood Top, Covered With Melamine Laminate, Mounted On A Tubular Structure. Benches With Particleboard Wood Seats, Covered In Melamine Laminate, Mounted On A Tubular Structure. Top And Seats In Particleboard Wood (Mdp), 25Mm Thick, Covered On The Upper Side In High Pressure Melamine Laminate, 0.8Mm Thick, Frost Finish. Lower Face Covering In Low Pressure Melamine Laminate - Bp, Frost Finish. Hurricane
|
