Tenders Are Invited For Construction Of A Municipal Warehouse Providing A Storage Base For Equipment Necessa ... in Poland

Work Detail

The Subject Of The Order Is The Preparation Of Complete Design And Cost Estimate Documentation And The Execution Of Construction Works In Accordance With The Developed Technical Documentation, An Investment Project Which Includes The Construction Of A Municipal Warehouse Providing A Storage Base For Equipment Necessary To Carry Out Tasks Requiring Civil Protection Together With The Necessary Infrastructure. Investment Address: 42-260 Kamienica Polska, Ul. Marii Konopnicka 226, Plot No. 1100, Rev. 0001 Kamienica Polska. The Planned Investment Is The Construction Of A Single-Story Municipal Warehouse With A Steel Structure, On A Rectangular Plan, For Which The Ordering Party Specifies The Following Requirements And Parameters: Usable Area Of ​​The Rooms In Total: Approximately 422.00 M2 (+/- 5%). External Dimensions Of The Municipal Warehouse: 15 X 30 Meters (+/- 5%). Height (Within The Meaning Of §6 Of The Regulation On The Technical Conditions To Be Met By Buildings And Their Location) Up To 10 Meters, With The Minimum Height From The Floor Level To The Lowest Element Of The Roof Structure Not Less Than 4.60 Meters. The Finished Ground Level At The Lowest Entrance To The Building Should Not Be Higher Than 0.05 M Above The Natural Terrain Level. Single-Pitch Or Gable Roof, Symmetrical, Roof Angle 5 - 15 Degrees, With Load-Bearing Capacity Enabling The Installation Of A Photovoltaic Installation (To Be Determined In Consultation With The Investor). External Sectional Garage Doors From The Front - 4 Pcs., Gate Height 4.20 M In The Clear View, Automatic, Controlled From A Remote Control And From A Controller Inside The Municipal Warehouse, Equipped With Automatic Detection Of Obstacles In The Gates View, With Light And Acoustic Operation Signals, Insulated, Inside Technical Steel Doors Between Rooms, 90 Cm Wide - 1 Pc, Outside Technical Steel Exit Doors, 90 Cm Wide - 1 Pc, Additionally A Sectional Gate Inside Between Rooms Inside 300 X 300 Cm - 1 Pc. Main Supporting Structure Galvanized Steel. Walls, Sandwich Panels, Mineral Wool Or Pir, Min. Thickness 100Mm. Roof Sandwich Panels Mineral Wool Or Pir Min. 100Mm. Close To The Border - A Fire Separation Wall With The Required Rei Parameters (To Be Determined In Consultation With The Investor). Epoxy Technical Floor – Minimum Load. 25 Kn/M2, Surface Hardened, Floated, Placed On A Foundation Slab. Under The Floor Insulation Thickness Min. 150Mm Xps. Linear Drains In The Floor Along The Axis Of Each Entrance Gate (Delivery And Installation Of A Separator Of Petroleum Substances From The Warehouse Floor To Be Consulted With The Investor). Reinforced Concrete Foundation Of The Building Up To A Height Of +30 Cm. Partition Wall Inside The Municipal Warehouse On A Steel Structure, Pir Sandwich Panel Or Mineral Wool, Min. 100Mm. 4.0 Kw Pv Installation On The Roof Of The Building. Lightning Protection Installation On The Roof, Electrical Installation In The Building - Provide Connection Power Of 20 Kw / Main Swit

Contact Information