Tender For Execution Of Various Works Within The Jurisdiction Of The Electricity Distribution Division, Pall ... in India

Work Detail

Tender For Execution Of Various Works Within The Jurisdiction Of The Electricity Distribution Division, Pallavpuram, Meerut—Specifically Covering The Operational Areas Of The Sub-Divisional Officers For Electricity Distribution Sub-Divisions I (Pallavpuram), Ii (Maliyana), And Iii (Gola)—Including The Guarding, Earthing, And Re-Sagging Of Power Lines Situated Along Covered Routes; The Installation Of Plastic Sheeting Up To A Height Of 7 Feet On Stp/Pcc Poles; And The Installation Of Signage Boards And Barricading Around Transformers, Among Other Related Tasks.- 1 Maintenance Work Of Protection Of Stp/Pcc Poles With Plastic Sheet, Barricading Of T/F (250 To 630 Kva T/F), During Kanwar Marg In The Area Edsd-I/Ii/Iii, Under Edd-Pallavpuram, Meerut. 2 Wrapping Of Stp/Pcc Pole With Pvc Insulation Sheet (Minimum 50 Micron), Minimum Till 7 Feet Height Or As Per Direction Of Supervising Enginner. Colour Of Insulation Sheet Will Be Confirmed By Department. Work Also Includes Wrapping Of 02 Rounds Of 2 Inch. Width Retroreflective Tape. Along With Supply & Fixing Of A-4 Size Danger Signage Stickers (Danger Signage Stickers Design Will Be Provided Supervising Enginner.) & Providing Gps Photos. 3 Providing And Fixing Of Flexi Signage Board Of Size 2 Feet X 2 Feet. Signage Board Must Be Properly Binded By Frame At Edges (Flexi Signage Board Language Will Be Provided By Supervising Enginner.) 4 Strong Barricading Of Distribution T/F With Wooden Balli (As Per Direction Of Supervising Enginner). Wooden Balli Must Be Digged In Atleast 2 Feet Inside The Earth. Barricading Must Have Horizontal Bracing Of Wooden Balli Atleast 04 Nos On Each Side And Providing Diagonal Bracing In-Cross On Each Side. Along With Supply & Fixing Of A-4 Size Danger Signage Stickers On Each Side.(Danger Signage Stickers Design Will Be Provided By Supervising Enginner.) & Providing Gps Photos. 5 Carriage Of Following Material From Store Center Pvvnl To Site & Vice-Versa Of Work Including Loading & Unloading At Both Ends Maximum Distance Up To 100 Km. As Per Direction Of Supervising Engineer. 6 Line Material Such As Ht/Lt Cross Arms, Ht/Lt Pin Insulator, Ht/Lt Pin, Ht/Lt Disc Insulator With Fitting, Stay Rod, Stay Wire, Lt Ab Cable, Conductor, Gi Wire, Earthing, J Hook, Gi Wire For Guarding, Ms Nuts & Bolts, Suspension Clamp Etc. 7 Earthing Of Each Ht/Lt Line Pole & T/F Properly After Drive Of Electrodes If Size 20Mm X 250 Mm And Connection The Earthing Point With Gi Wire. (As Per Uppcl Respo).

Contact Information