|
1. The Subject Of The Order Is Current Vertical And Horizontal Signage In The City And Commune Of Busko-Zdrój - In Accordance With Chapter Iii, Section 1 Swz And Annex No. 1A To The Swz (Detailed Offer Form). 1.1. The Scope Of Horizontal Markings Should Include The Following: A) Thin-Layer Horizontal Road Markings - Horizontal Road Signs Placed On The Surface In The Form Of Solid Or Dashed, Single Or Double Lines, Arrows, Inscriptions, Symbols And Other Lines Related To The Marking Of Specific Places On This Surface, B) Transverse Signs - Designating Places Intended For Pedestrians And Cyclists Across The Road And Places Of Vehicle Stopping, C) Supplementary Signs - In The Form Of Symbols, Inscriptions, Bus Stop Lines And Other Defining Special Places On The Surface, D) Removal Of Road Markings By Milling, Sandblasting Or Other Means.1.2. The Annual Quantity Of Works Is An Estimated Quantity Determined On The Basis Of The Volume Of The Completed Order In 2025. This Quantity May Change (Decrease Or Increase The Scope). The Remuneration Due To The Contractor Will Be Determined On The Basis Of The Actual Quantity Of Works Performed, Taking Into Account The Unit Prices Given In The Offer.1.3. Securing And Marking Work Sites Is The Responsibility Of The Contractor.1.4. The Contractors Material Is New And Has A Quality Certificate.1.5. Requirements For Materials: A) Road Signs Type A, B, C, D, E, F, G, T, U, Speed Bumps And Road Mirrors Should Have A Certificate Issued By The Road And Bridge Research Institute Or Other Authorized Units, B) Signs Should Be: - Made Of Type Ii Foil (Ii Generation) For Signs With Symbols: A-7, B-2, B-20, D-6, D-6A, D-6B, - Made Of Type Ii Foil (Second Generation) I (1St Generation) For Other Signs And Boards, - Made Of Galvanized Sheet Metal, - Double Bent Around The Entire Circumference, - Painted With Powder Paint. C) Sign Posts Should Be Made Of Galvanized Pipes With A Diameter Of 60 Mm, They Should Have Anchors That Prevent The Element From Rotating (After Its Installation) In The Ground Around Its Axis. The Lengths Of The Posts Should Be Adjusted Depending On The Configuration Of The Marking Mounted On Them, While Maintaining The Required Vertical Gauges Specified In The Regulation Of The Minister Of Infrastructure Of July 3, 2003 On Detailed Technical Conditions For Road Signs And Signals As Well As Road Traffic Safety Devices And The Conditions For Their Placement On Roads (Journal Of Laws Of 2019, Item 2311, As Amended). D) Materials For Horizontal Road Marking - Materials Containing Solvent-Free, Solvent-Free Or Point Reflective Elements Which May Be Applied Or Incorporated By Painting, Spraying, Casting, Embossing, Rolling, Gluing, Etc. Onto Road Surfaces, Used At Ambient Or Elevated Temperatures. These Materials Should Be Retroreflective. E) Thin-Layer Road Markings Should Be Made By Applying A Layer Of 0.3 To 0.8 Mm Thick Wet Layer Using Reflective Glass Beads. F) Thick-Layer Road Markings Should Be Made By App
|
