Tender For Re Routing 11 Kv Kayyur Feeder From Plavalapp To Muzhakkom Homeo Under Electrical Section, Kayyur in India

Work Detail

Tender For Re Routing 11 Kv Kayyur Feeder From Plavalapp To Muzhakkom Homeo Under Electrical Section, Kayyur- 1 Fitting And Providing One Ht Stay For 11Kv Pole, Including Digging And Back Filling Pit In Ordinary Soil. 2 Fitting And Providing One Strut Using Ht Psc Pole Including Digging And Back Filling Pit In Ordinary Soil. 3 Labour Charges For Loading Ht Psc Pole From The Stacking Place And Unloading The Same At Work Site (Transportation By Any Vehicle). 4 Fitting And Providing One Ht Fly Stay For 11Kv Pole Using Ht Psc Pole Including Digging And Back Filling Pits In Ordinary Soil, Drawing Sufficient Length Of Gi Earth Leads To The Ground For Earthing (Excluding Provision Of Earthing). 5 Stringing Of One Km 3 Ph 11Kv Line With Xlpe Insulated Acsr Raccoon Or Equivalant (3 Conductors) After Fitting Insulators, Binding Conductors To Pin Insulators Using Suitable Tie And Anchoring With Wedge Type Anchoring Clamps Including Cutting And Removing Tree Branches Wherever Necessary Excluding Cut Point Works. 6 Dismantling (Without Damage) One Km 11Kv Line (Three Conductors) Including Dismantling Cross Arm, Insulators, Disc, Disconnecting Jumper Connection, Rolling The Conductor And Stacking The Materials. 7 Dismantling One Damaged 11Kv Psc/Rcc Pole After Disconnecting Stays, Strut Etc. Attached Thereon And Stacking The Same. 8 Dismantling One Damaged Lt Psc/Rcc Pole After Disconnecting Stays, Strut Etc. Attached Thereon And Stacking The Same. 9 Dismantling (Without Damage) One Lt Psc/Rcc Pole After Disconnecting Stays, Strut Etc. Attached Thereon And Stacking The Same. 10 Transferring Lt Single Phase 2/3 Wire Oh Line To Newly Erected Ht/Lt Pole Including Dismantling Existing Cross Arm And Insulators, Refitting The Same On The New Pole, Binding Etc. Complete. 11 Transferring Lt Three Phase 4/5 Wire Oh Line To Newly Erected Ht/Lt Pole Including Dismantling Existing Cross Arm And Insulators, Refitting The Same On The New Pole, Binding Etc. Complete. 12 Disconnecting And Lowering Down The Single Phase Wp Service Connection With Guy Wire From The Oh Line And Reconnecting The Same After Completing The Line Work. 13 Dismantling (Without Damage) One V Cross Arm/Channel Cross Arm From Existing Pole And Bringing Back To Section Store. 14 Dismantling (Without Damage) One Channel Cross Arm From Existing Dp Structure And Bringing Back To Section Store. 15 Additional Rate For Excavation Of One Pit For Ht Pole/Ht Stay In Hard Laterite. 16 Additional Rate For Excavation Of Pit For A Type Pole In Hard Laterite. 17 Additional Rate For Excavation Of One Earth Pit (2.5M Depth) In Hard Laterite. 18 Doing One Cable End Termination On 11Kv 99Sqmm Aaac Covered Conductor (1 Conductor) And Connecting To Existing Mvt Or Other Terminals, Including Charges For Cable Jointer Etc. Complete As Per The Direction Of The Departmental Officers. 19 Fiting One No Mvt On Existing Cross Arm Excluding Termination Work (For One Phase) Of Any Rating For 11 Kv Ab Cable 20 Providing Midspan Joint For 11Kv 99Sqmm Aaac Covered Conductor (1 Conductor) 21 Providing One Earth Using Gi Earth Pipe Of Size 38.1Mm Dia, 2.5M Length Including Digging Separate Pit (0.45X0.45X2.5M) At Standard Distance (1.5M) Away From The Pole/Structure In Ordinary Soil & Backfilling The Pit With 15Cm Alternate Layer Of Charcoal, Salt And Sand Up To 90Cm From The Bottom. Including The Cost Of 20Kg Salt, 25Kg Charcoal, Excluding Supply Of Earth Pipe.

Contact Information