|
Low Storage Module With 2 Doors: Module In Carbon Steel, Mdf And Abs, Which Can Be Dismantled Into 8 Parts: 2 Sides, 1 Bottom, 1 Base, 1 Headboard, 2 Doors, 1 Dividing Shelf. Upper And Lower Closure In Gray Abs, With 4 Mm Wall Structure. The Module Is Assembled Using Screws And Rivets. The Feet Of The Module Are Made Of Gray Injected Plastic With A Screw That Allows For Adjustment. Folding Key Lock. Cabinet Body Made Of 0.75 M Thick Steel Sheet. Right And Left Sides Of The Cabinet, With Racks Printed Directly On The Side, With A Minimum Adjustment Of 100 Mm Between The Points, Allowing The User To Place The Shelf At Various Heights. Base Structured Using Carbon Steel Tube 25X25mm Square On The Wall 1.5 Mm, Two Doors Made Of 18 Mm Mdf, Covered On Both Sides In Low Pressure Melamine Laminate In White Color, With Edges Covered In Abs Tape. Each Door Must Have 2 Hinges And A Plastic Handle. The Bottom Of The Module Has 01 Closure In 6 Mm Mdf, Covered On Both Sides In White Melamine Laminate. All Steel Parts Must Receive Treatment Through Successive Baths For Protection Through Phosphating, Electrostatic Epoxy Powder Painting, In Textured White. Welds Must Have A Smooth And Homogeneous Surface And Must Not Have Sharp Points, Rough Surfaces Or Slag. Spatters And Welding Irregularities, Burrs And Sharp Corners Must Be Eliminated. Edges Accessible To Users Must Be Rounded. Each Module Must Have An Assembly Manual In Its Packaging. Approximate Dimensions: Height 80 Cm, Width. 95 Cm, Prof. 43.5 Cm., Tall Storage Module With 2 Doors: Carbon Steel Module, Can Be Disassembled Into 11 Parts: 2 Sides, 1 Bottom, 4 Dividing Shelves. Upper And Lower Closure In Gray Abs, With 4 Mm Wall Structure (In Any Cross Section), With 6 Castles For Fixing To The Rectangular Structure, (Tube 25 X 25 Mm) Use For Joining Between The Plastic Base And The Rectangular Structure, Special Screws For Plastic. The Module Must Have The 12 Vertices That Make Up Its Shape, With A Radius Of At Least 50 Mm, Without Meetings And Edges With Sharp Corners. The Module Is Assembled Using Screws And Rivets. The Feet Of The Module Are Made Of Injected Plastic In The Same Gray Color, With A Round Shape And A Diameter Of 50 Mm, A Height Of 25 Mm, A Shoe Wall With A Thickness Of 3.5 Mm, The Final Edge In Contact With The Chamfered Floor With An Inclination Of 45° And A Height Of 2 Mm, With A 5/16 Central Screw That Allows Adjustment. Cylindrical Drum Type Lock With Folding Key. Cabinet Body Made Of Steel Sheet Sae 1010/1020 Thick, 75 Mm. Right And Left Sides Of The Cabinet, Allowing The User To Place Shelves At Various Heights. Base Structured Using Sae 1020 25 X 25 Carbon Steel Tube, Square On Wall 1, Forming A Rectangle With 890 Rectangular Structure To Form The Four Legs Of The Cabinet. Insert Internal Bushings With A 5/16 Inch Diameter Nut That Will Receive The Bulged Shoes Into Their Ends. Two Doors Made Of 18 Mm Mdf, With Edges Covered In 2.5 Abs Tape, Bookshelf
|
