Tender For Expression Of Interest For Outsource Repair Facility For Qty 16 Different Lrus Of Aviation Fleet in India

Work Detail

Tender For Expression Of Interest For Outsource Repair Facility For Qty 16 Different Lrus Of Aviation Fleet; 2.1 Power Amplifier Module: Transmit channel (PA Module) consist of cascaded power amplifiers, which amplify the input power to an output power of 100 Watt. 2.2 Transmit Receive Module, IFF (TRM): It is used for both transmission and reception of signals for systems like radar and communications. 2.3 Digital Flight Data Recorder: Flight Data Recorder is used to record emergency flight data in a form of double-frequency sequential code at the data input speed of 256 words/sec and to save this data in case of the aircraft accident. 2.4 Digital Flight Recorder: Flight Data Recorder is used to record emergency flight data in a form of double-frequency sequential code at the data input speed of 256 words/sec and to save this data in case of the aircraft accident. 2.5 TASU: Tilt Angle Sensor Unit (TASU) is included in the ground C-Band Segment (G-C-Band) is and provides the antenna Post Rotary Mast (AP RM) tilt angles measurement in relation to the horizon. 2.6 Remote Control Unit: It provide C-band shelter power supply control, distributes it to the consumers, monitors C-band shelter equipment serviceability, thermal mode in C-band rack and under C- radome, receives angular automatic channel data and generates pointing error signal for antenna pointing system (APS) control. 2.7 Single Board Computer: It is used to de3liver parallel signal Processor (PSP) processed results to the radar Controller (RC) through Ethernet interface. 2.8 Deicer Control Unit (DICU): It is a line replacement unit of ground satellite communication segment ICCSG-SATCOM. DICU controls electrical heaters for deicing system of antenna mount system G-AMS, and it is used together with unit of sensors for automatic switch-on of electrical heaters in case of icing conditions. 2.9 MCS Server: Interfacing with all MSA system via LAN communication channel implemented by the data communication switch. It runs all the software (CSCIs) that manages various systems of MSA. 2.10 Control Console: Its purpose is to select different modes, range, ground speed selection etc. 2.11 SRUT with unit: It is used for holding transmitter. 2.12 Monitoring Unit: It is used to monitor the aircraft motion parameter and serviceability of autopilot yaw rail and pitch channel in automatic control. 2.13 KP2 Receiver: aircraft larger radio array. It is used for as an pre amplifier component with in 2.14 Power Unit: It is used to produce various DC voltages and computer power fail signal for KP-1 Nav computer except IOD & GNOM-A. 2.15 Control and Indication Unit: It is used for feedback and status. information. 2.16 G-FES Front End Assy: It is used for transmitting, receive and conditioning radar signal before they are processed by backend electronics.

Contact Information