Tenders Are Invited For Laboratory, Optical And Precision Equipments (Excl. Glasses) – Broadband Vector Netw ... in Germany

Work Detail

Laboratory, Optical And Precision Equipments (Excl. Glasses) – Broadband Vector Network Analyzer (Vna) System. Technical Requirements: - The Measurement System Shall Operate In A Seamless Frequency Range From 10?Mhz To 250?Ghz Without Band Switching. - The Connection Between The Base Analyzer And The 250 Ghz Millimeter-Wave Frequency Extenders Shall Be Realized Via A Control And Distribution Unit Capable Of Managing Rf, Lo, And If Signal Paths With Full Phase And Frequency Synchronization Across All Modules. - The Base Vna Shall Provide At Least 4 Test Ports Supporting Differential S-Parameters Measurements Up To 250?Ghz. Additional Features, Such As Extended Multi-Port Capability Or Automation Options, Will Be Additionally Scored In The Technical Evaluation. - The Bidder Shall Provide The Source Output Power (In Dbm) Of The Single Sweep Extenders For Frequency Ranges Up To 170 Ghz, 220 Ghz, And 250 Ghz. The Output Power Values Will Constitute One Of The Evaluation Criteria - Higher Output Power Within The Respective Frequency Ranges Will Be Awarded Additional Points As Part Of The Technical Evaluation. Minimum Requirement: The Output Power Shall Be ? -20?Dbm In The 220?Ghz - 250?Ghz Range. - The Declared Dynamic Range Values Will Constitute One Of The Evaluation Criteria - A Higher Dynamic Range Within The Respective Frequency Ranges Will Be Awarded Additional Points As Part Of The Technical Evaluation. The Tenderer Shall Provide The System Dynamic Range (In Db) For The Following Frequency Ranges: - From 500?Mhz To 20?Ghz; - From 20 Ghz To 170 Ghz - From 170 Ghz To 220 Ghz - From 220 Ghz To 250 Ghz Minimum Requirement: The System Dynamic Range Shall Be ? 75?Db - The Base Vna Must Provide Integrated Bias-Tees Up To 40?V Dc On Each Port. - The Base Unit Shall Include Internal Combiners And Switches To Enable Dual-Tone Measurements. - Built-In Attenuators (Both Source And Receiver Paths) Up To 50?Db In 10?Db Steps. - The Base Frequency Range Shall Extend Up To At Least 67?Ghz. - The System Must Be Fully Compatible With Mmwave Frequency Extenders For 250?Ghz Operation. - The Declared Phase Noise Level Will Constitute One Of The Evaluation Criteria - A Lower Phase Noise Value Will Be Awarded Additional Points As Part Of The Technical Evaluation. The Tenderer Shall Provide The Phase Noise Level (In Dbc/Hz At 10 Khz Offset) Of The Base Analyzer For The 1 Ghz - 67 Ghz Frequency Range. - The Dynamic Range Of The Base Unit: ??127?Db (0.5?-?26.5?Ghz) And ??106?Db (0.05?-?67?Ghz). - Frequency Extender Modules Shall Include Integrated Bias-Tees And Provide Stable, Low-Phase-Noise Operation. - Cabling Between Base Vna And Extenders Shall Be At Least 1?M In Length Per Channel. - The Vna Software May Currently Provide Additional Measurement Applications, Such As Gain Compression Measurements, Scalar Mixer / Converter Measurements And Differential And I/Q Device Measurements As An Added Value. These Current Capabilities Will Be Considered In The Technical Evaluation, And Higher Functionality Will Receive More Points. - The Software Must Allow Future Upgrades

Contact Information